1 /
1
KATON FKM FK2 FKM O-RING
Description：
KATON® FKM FK2 is a medium viscosity, high fluorine(70%), peroxide curable fluoroelastomer.
KATON® FK2 is a medium viscosity, high fluorine(70%), peroxide curable fluoroelastomer.
KATON®FK2 exhibits superior resistance to a wide variety of chemicals, coupled with excellent processability and optimum compression set. KATON® FK2 can be cross-linked using organic peroxides in conjunction with a co-agent.
Some of the basic properties of KATON® FK2 are：
KATON®FK2 exhibits superior resistance to a wide variety of chemicals, coupled with excellent processability and optimum compression set. KATON® FK2 can be cross-linked using organic peroxides in conjunction with a co-agent.
Some of the basic properties of KATON® FK2 are：
• Low post cure
• Superior mold flow
• Lack of mold fouling
• Excellent mold release
• Good chemical resistance especially in:
- Alcohol containing fuels
- Steam
- Fluids containing amine additives
KATON® FK2 can be used for compression, injection and transfer molding of shaft seals, valve seals, O-rings,gaskets or any item requiring superior chemical resistance.
KATON® FK2 can be combined with the cure system and other typical fluoroelastomer compounding ingredients. Mixing can be accomp-lished with two-roll mills or internal mixers. Finished goods may be produced by a variety of rubber processing methods.This material can be extruded intohoses or profiles and can be calendered to make sheet or belting.
• Superior mold flow
• Lack of mold fouling
• Excellent mold release
• Good chemical resistance especially in:
- Alcohol containing fuels
- Steam
- Fluids containing amine additives
KATON® FK2 can be used for compression, injection and transfer molding of shaft seals, valve seals, O-rings,gaskets or any item requiring superior chemical resistance.
KATON® FK2 can be combined with the cure system and other typical fluoroelastomer compounding ingredients. Mixing can be accomp-lished with two-roll mills or internal mixers. Finished goods may be produced by a variety of rubber processing methods.This material can be extruded intohoses or profiles and can be calendered to make sheet or belting.
| Cost Performance Ratio | ||||||
| FK1 | FK2 | FK3 | FK5 | FVQM | FEPM | FFKM |
| ★ (Low Price) |
★★ (General Price) |
★★★★ (High Cost) |
★★★ (Median Price) |
★★★★ (High Cost) |
★★★★ (High Cost) |
★★★★★ (Very High Cost) |
